Controls
7 - 3
Start backtack
● This function key is not used on this machine.
End backtack
● This function key is not used on this machine.
Needle position
● If this key is pressed the "needle raised after sewing stop" function is switched on or off.
When the function is switched on, the needle positions at t.d.c. after sewing stops.
Foot position after stop
● This function key is not used on this machine.
Foot position after trimming
● This function key is not used on this machine.
Thread trimmer
● If this key is pressed the thread trimming function is switched on or off.
Darning program
● This function key is not used on this machine.
Counted seam
● This function key is not used on this machine.
TE/Speed
● If this key is pressed once the speed limit for the sewing mode is activated.
● If this key is pressed twice (within 5 seconds) the machine changes from sewing to input
mode.
To Next Page
Loading...
