Pfaff 130-6 - 10. To regulate the length of stitch

z
Fig. 11
Loosen regulator screw,
and push up to desired
posi-
tion from
1 to 5. Position
one is the smallest
stitch. When
you
have chosen the size
of stitch you want, tighten
the
screw. To sew
in reverse, simply push
the locked screw
downward,
below position zero.
It will automatically sew
the
some size stitch
in reverse.
11. The Dial-A-Stitch
If the nose of the Dial-A-Stitch
lever (G),
(Fig. 12), is
on point
zero of the scale, the
machine is performing the
straight stitch.
If you turn the lever,
(G), to the left,
the
,machine is doing
the zigzag stitch.
The width of the zig-
zag stitch is increased
asthe lever,
(G), is turned to the
left, bringing
the width of the
zigzag stitch up
to a
maximum of 11/64".
If lever H (Fig. 12)
is pressed against the
body of the
machine,
and then shifted
down into position II, the
ma-
chine will sew to the
right of the stitch made
in the nor-
.mal position. In
position III, it will sew
still farther to
the right, continuing
the same kind of
stitch for which the
14