Pfaff 130-6 User Manual

Thread
breaking
may be
caused by;
1.
Any
of
the
three
reasons
mentioned
above.
2. Tension
too
tight.
3. Using
bad
or
knotty
thread.
Bad
stitches
may
be
caused
as
a result
of;
1. Tensions
being
too
loose
or too
tight.
Both
tensions
should
be
equal.
2.
Using
needles
and
threads
that
do
not
conform
to
the
thickness
of
the
fabric.
Top
and
bottom
thread
should
be
the
same.
3.
Fluff
having
accumulated
between
the
upper
tension
discs,
or
underneath
the tension
spring
of
the
bobbin
case.
Heavy
working
of
the
machine
may
be
caused
by:
1.
The
motor
belt
having
become
too
loose
after
con-
stant
use,
therefore,
not
pulling
properly.
In that
case,
the
motor
bracket
has
to be
adjusted.
2. The
motor
belt
being
too
tight.
Do
not
over-tighten
it.
3. The
shuttle
race
being
obstructed
by
fluff,
which
must
be removed.
4. The
machine
having
become
clogged.
Note
the
fol-
lowing
instructions
for
proper
oiling
and
cleaning.
II.
To
oil
and
clean
the
machine
Apply
rust-proof
grease
on
all
nickel-plated
and
polished
parts.
This
done,
all
greased
parts
should
be
cleaned
with
a
clean
rag.
Then,
apply
a
little
PFAFF-Sew-
ing
Machine
Oil
at
the
oiling
points
marked
with
arrows
in Figures
1,
2, and
3.
2

Pfaff 130-6 Specifications

General

Brand	Pfaff
Model	130-6
Category	Sewing Machine
Language	English