Pfaff 360 User Manual

Hoving mode sure that the position of the driving eccentric on the arm shaft is
correct, take the automatic mechanism in your left hand (in the posit fi on shown
in Fig. 111) and , with the index finger of your left hand, push against the pro-
truding end of the driving lever which carries the driving roller. Push regulating
Fig. 111 AutomoJic embroidery mechanism, ready for instollotion
sl ide c ( Fig . 109) to the left until nose b of the connecting lever is positioned
slightly
behind the stop pin on the regulating slide, as shown in Fig. 109. If the
regulating slide is pushed too far to the left, it will strike against the needle
bar frame pitman.
Thus prepared, the automatic embroidery mech·onism can be installed into the
machine without any difficulty. It is secured in position by three screws, Make
sure
tnat disengaging lever e (Fig. 109) lifts the two forward engaging levers,
without binding, when you turn stitch width dial
A. Also check
a. whether the top contact finger of contact finger assembly D (Fig. 111) is lo-
cated below the red mark when dial D is turned so that number 1 is op-
posite this mark, and
b. whether the two set screws on the back of dial C are arranged in a hori-
zontal line when this dial is set on "0". If adjustment is required, loosen
the two set screws and adjust the position of the com (50506) on the stud.
This setting must
also be preserved when the dial is replaced by a new one.
74

Pfaff 360 Specifications

General

Type	Mechanical
Free Arm	Yes
Presser Foot Pressure	Adjustable
Built-in Needle Threader	No
Stitch Functions	Straight stitch, zigzag stitch, decorative stitches
Needle Position	Adjustable
Stitch Width	Up to 5mm
Buttonhole Styles	4-step
Presser Feet	Buttonhole