4:3
Sequencing
Using the alphabet (1.0)
Alphabet mode overview
1. Font selection/font preview
2. Name of selected font
3. Stitch fi eld
4. Keyboard
5. Change character set (upper case/lower case,
normal/special symbols)
6. Delete
Create a text sequence
• Press the left or right arrow buttons on the
wheel to step to alphabet mode (A).
• Press the up arrow button until the font
preview (1) at the top of the display is selected.
Press OK (B) to open a list of available fonts.
Step to desired font with the arrow buttons
and press OK (B) to select it.
• Press the down arrow button twice to step
to the keyboard. Move around the keyboard
using the arrow buttons and press OK (B) to
add a letter or character to the sequence. Each
letter will be placed at the cursor position in
the stitch fi eld.
Note: The selected letter on the keyboard will be
highlighted.
• To move the cursor in the sequence, use the
arrow buttons to step to the stitch fi eld (3) and
then press the left and right arrow buttons
to move the cursor back and forth in the
sequence.
Select character set
Press the arrow buttons to step to the character set
icons (5). Press OK (B) to step between the available
character sets: upper or lower case, normal or
special letters and numbers and symbols.
Note: Lower case characters are only available for the
Block font.
ambition™ 1.0
1
3
4
6
2
5
A
B
To Next Page
Loading...
Need help?
General
