Operating the machine
19
Removing the presser foot
Switch off the master switch (12).
Raise the needle to its highest position.
Press the front of the presser foot up and
the rear of the presser foot down until it
disengages from the presser foot holder
(20).
Attaching the presser foot
Place the presser foot under the presser
foot holder (20) so that when the presser
bar lifter (26) is lowered, the pins of the
foot engage in the presser foot holder.
Check:
Please check that the presser foot is
properly attached by raising the presser
bar lifter.
To Next Page
Loading...
Need help?
General
