Accessories and needles
56
Bias tape binder
Binding with bias tape is a very easy
method of giving fabric edges a smooth
and neat appearance. For this you need
unfolded bias tape about 1ß (24 mm) wide.
• Remove the presser foot and holder. At-
tach the bias binder.
• Cut the beginning of the bias tape at a
diagonal.
• Feed the tape into the scroll of the
binder and pull out to the back.
• Adjust the binder and/or the needle
position so that the needle pierces the
fabric approximately 1/16ß (1-1.5 mm)
from the folded edge of the bias tape.
• Stitch about 1ß (2.5 cm) along the bias
tape.
• Insert the edge of the fabric to be bound
between the bias tape edges into the
slot of the binder. The bias tape will en-
close the raw edge automatically during
sewing.
Tip: You can obtain an additional deco-
rative effect by using a zigzag or fancy
stitch.
RufÁ er
With the rufÁ er you can make closely or
widely spaced pleats automatically while
sewing. This is very useful for rufÁ es, frills,
home textiles, etc.
The rufÁ er can be used in three different
ways:
1. Folding and securing pleats in fabric.
2. Folding pleats in fabric and securing to
a second fabric in one operation.
3. Folding pleats in fabric, attaching lace
and securing to another fabric in one
operation.
When you buy the rufÁ er from your
PFAFF dealer, full operating instructions
are included.
To Next Page
Loading...
Need help?
General
