Pfaff QUILT ARTIST II - Create Set Point and Undo

32
6. After you have rolled your quilt you need to tell
the machine where your fi rst mark is. Move your ma-
chine to the fi rst mark and touch “OK”.
7. Move to your second mark and touch “OK”.
8. You will now need to select the reference point
you want to use to nest. Move your machine and the
crosshair on the screen will move as well. Once your
crosshair is over the point you want to use to nest,
touch the check mark. You are only watching your
screen at this point, do not look at your quilt.
9. The pattern previously quilted will appear on the
screen, move your machine until the new pattern nests
how you want it to nest and touch the check mark. You
are only watching the screen.
Create Set Point: A “setpoint” is when you are go-
ing to be making modifi cations to a pattern or box
and you’re not sure how it’s going to turn out. You
can “create a set point, do all your modifi cations and
if you don’t like them touch “restore set point” and it
will go back to the place it was when the point was
created.
Undo: Able to undo the last operation. You can only
undo the last operation.