11
Step 7: The belt should now be positioned just be-
side the gear on the backside of the motor box. With
the top lever on the motor box in the “open” posi-
tion, slide the belt between the gear and the metal
pulley. Once the belt is seated into the gear, move
the lever on the top of the motor box to the “closed”
position.
See fi gure 2-20 this shows the lever for open and closed posi-
tion of the motor box x-belt pulley.
See fi gure 2-21 shows the belt in the pulley area of the motor
box.
Note: Belt teeth facing up into the gear.
Step 8: Locate the Gear Guard and two locknuts.
Place the Gear Guard so that it covers the gear on
the top of the motor box, and the two holes line up
with the threaded posts on the left edge of the motor
box. Secure with locknuts.
See fi gure 2-22
Note This is not used when setting up on the iQuilt frame.
Figure 2-22
Figure 2-21
Figure 2-20
Release / Engage
lever for the X-belt
pulley assembly
To Next Page
Loading...
