Pfaff QUILT ARTIST II - Section 3: Attaching the Quilt Artist II; Attaching Power to Motor Box; Attaching to the PFAFF Power Quilter p3 Machine

12
Section 3: Attaching the Quilt Artist
™
II
Attaching Power to Motor Box
Step 1: Locate the power cord that came with your motor
box.
Step 2: Locate the power plug on the left side of the motor
box. Note: If facing the front of the box.
Step 3: Plug the power cord into the motor box
Step 4: Ensure the power cord is pointing towards the top
of the box and not towards the ground. See fi gure 3-1
Step 5: Run the power cord across the top to the other side
of the box.
Step 6: Leave the power cord there until all other needed
cables have been attached
Attaching to the PFAFF
®
PowerQuilter
™
p3 machine
Step 1: Locate the black cable stitcher cable that came with
your Quilt Artist
™
II.
Step 2: Plug this cable into the “Robotics” port at the rear
of your machine. See fi gure 3-2 and fi gure 3-3
Figure 3-3
Figure 3-2
Figure 3-1