13
Step 3: Run the other end of the black stitcher cable to the mo-
tor box and plug into the “Stitcher Box” port.
See fi gure 3-4
Note: Along the side of the carriage.
Step 4: From the motor box run these two cable between your
upper and lower carriage.
Option: The power cord and stitcher cable are the only two
cables needed. Run these cables along the side of the bottom
carriage and zip tie using a base anchor near the front and the
rear of the bottom carriage. See fi gure 3-5 thru 3-7
Step 5: Plug the power cable into your surge protector.
Step 6: Ensure the stitching cable is plugged into rear of the
machine as noted in step #2.
Step 7: Your Quilt Artist
™
II is now setup and ready to insert
the SD card with the patterns.
Figure 3-7
Figure 3-6
Figure 3-5
Figure 3-4
To Next Page
Loading...
