PGO G-MAX - POWER DISCONNECTION SWITCH; PRE-RIDING INSPECTION

25
POWER DISCONNECTION SWITCH
The power disconnection switch will be activated to stall the motorcycle within 6 seconds in case of rollover of
a running motorcycle.
It is necessary to disconnect and reconnect the power supply for next start-up with the stalled motorcycle
supported.
Attention:
• Some error messages (Code: P0261) will be indicated on the display panel with the power disconnection
switch activated. These messages are not disadvantageous to the vehicle.
• Bring the tumbled motorcycle to any PGO dealer for further check.
PRE-RIDING INSPECTION
Please do the inspection as following before riding:
PRE-RIDING INSPECTION
Please do the inspection as following before riding:
ITEM PROCEDURE PAGE
FRONT BRAKE Check the brake function, clearance , brake oil level, see if it is leaking.
If necessary, may refill FMVSS DOT 4 OR SAEJ 1703 brake oil.
28 50
REAR BRAKE Check the brake function and clearance, proper adjustment if necessary. 28 50
THROTTLE GRIP Check if it is smooth, put some lubricant . 34
LUBRICANT Adjustments if necessary.
Check the oil level/according to the request to refill oil.
31
ENGINE COOLANT Check the coolant level, refill it to the upper level if it is below the lower level. 30
TIRE Check the pressure, the wear out situation. 33
CONTROLLER
/GAUGE CABLE
Check if smooth operation. Add lubricant if necessary. ─
BRAKE LEVER(HANDLE) Check if smooth operation. Add lubricant if necessary. 28
CENTRAL STAND Check if smooth operation. Add lubricant if necessary. ─
ASSEMBLY
/FITTING
Check all the assembling parts, fixing & adjusting if necessary. ─
FUEL TANK Check the fuel level. Refill up if necessary. 24
LAMP/SIGNAL LIGHTS Check if it is operating good condition. 34
26 46
26 46
31
29
28
30
26
23
31