PGO G-MAX - EXHAUST CONTROL SYSTEM MAINTENANCE

42
REMARKS
：
1. A: adjust C: clean I: inspect, or replace if necessary L: lubricate R: replace
2. Items with “*” mark indicate our recommendation to have it done by PGO dealer.
NOTE 1
：
For 4T engine, the engine oil shall be changed completely after run-in period 300km or one month later.
This can make sure the engine runs smoothly.
NOTE 2
：
The exchange of brake uid
1. After disassembling of brake main cylinder or caliper, do change the new uid.
2. Check the uid level often, Rell if necessary.
3. Change the oil seal of main cylinder and caliper every two years.
4. Change the brake uid hose every four years.
Note3
：
Water-cool engine
1. Clean the lter of cooling fan per 3,000kms.
2. Check the clamping and hoses of radiator system initially 3,000kms.
3. Replace the engine coolant every two years.
Exhaust control system (only be valid for the bike equipped catalyst)
：
Catalyster will not be possible to be withdrawn individual, the only you have to do is to maintain fuel,
ignition, intake/exhaust system periodically.
1. Maintenance procedure of air clearer (see page 43).
2. Spark plug’s checking: please repair or replace if spark plug is dirty.
3. Fuel system’s checking: please repair or replace if fuel pipe is jammed or broken.
4. Mufer’s checking: please x tightly once or renew a gasket if it is leaking.
5. Idle rpm’s checking: please x tightly once or renew a gasket if throttle cable.
6. Exhaust density checking while idle: please left the job to any service center of anti-pollution inspection
for carburetor adjusting.