Copyright @ 2014 Phicomm Europe GmbH – print only for private use!
page 16 of 49
4. Wireless router configurations
This section gives instructions of the procedures that must be performed to enable
the wireless router.
After completion of the third point the router is connected with the internet. Please
select the corresponding internet connection on your PC and click connect.
4.1 TCP/IP settings
The IP address has to be obtained automatically before starting the configuration of
the router. Please follow these steps:
1. With the right mouse button please click on the right bottom corner. Click Open
Network and Sharing Center and select Change adapter settings on the upper left of
the screen.
2. Select network connection type and open the Properties. In the Properties window
please double click Internet Protocol Version 4 (TCP/IPv4).
To Next Page
Loading...
Need help?
General
