Adjust Volume
©
VOLUME
Q
Still Mode
You can pause the image shown on theTV screen.
Press FREEZE to pause the image shown on theTV screen.
• The sound output will not be paused.
• If no signal is detected or protected signal is received during still
mode, the image remains paused and the sound output will be
muted,
• The still function will be released after 5 minutes.
To cancel still mode, press any button except IdO(Standby-On).
Watch Channels from a Set-top Box
To watch channels from a set-top box
t Switch on the set-top box.
L_ The picture from your set-top box might appear automatically
on theTV screen.
2. Use the remote control of your set-top box to select channels.
If the picture does not appear
To increase or decrease volume
Press VOL +/- on the remote control or press VOLUME +/- on
the side oftheT_,
To mute or unmute sound
Press MUTE on the remote control to mute the sound.
Press MUTE again to restore the sound.
t Press SOURCE repeatedly to select the set-top box and wait a
few seconds for the picture to appear.
2 Use the remote control of your set-top box to select channels.
Watch Connected Devices
To watch connected devices
t Switch on the connected device.
L_ The picture from your connected device might appear
automatically on theTV screen.
_2 Use the remote control of the device to select channels.
If the picture does not appear
t Press SOURCE repeatedly to select the connected device and wait
a few seconds for the picture to appear.
2 Use the remote control of the device to select channels.
12 EN
To Next Page
Loading...
