4 Get Started Insert the Remote Control Batteries
This section supplements information in the Quick Start. For
information about how to mount and install yourTV, refer to the Quick
Start.
Position the TV
Warning
" Do not insert the power plug into the waEI socket before aEIthe connections are
made,
" Large screenTVs are heavyTwo people are required to carry and handEe a larse
screen T_
• Before you move the T_, disconnect the cables to prevent breakage,
t Slide the batter 7 cover offthe back of the remote control.
_- Insert the 2 supplied batZeries (AAA). Be sure the + and - ends of
the batZerfes line up with the markings inside the case.
3 Slide the cover back into position.
In addition to reading and understanding the safety instructions,
consider the following before positioning yourTV:
• Ensure that you always have easy access to the AC power cord or
plug to disconnect theTV from the power.
• IftheTV ismounted on a swivel base, ensure that no strain is
placed on the AC power cord when theTV is swiveled. Strain on
the AC power cord can loosen connections.
• The ideal viewing distance for watchingTV isthree times its screen
SiZe.
• Position the TV where light does not fall on the screen.
• Connect your devices before you position theT_.
Use a Kensington loci<
There is a Kensington security slot on the back oftheT_. Prevent theft
by looping a Kensington loci< between the slot and a permanent object,
such as a heavy table.
° 0@
" Remove the ba±teries if not using the remote control for an extended period of time.
Connect the Antenna or Cable
iiiii{{i i
iiiiii iii
_ Cable
Connect to an antenna
Any DTV programs that are broadcast in your area can be received for
free through an antenna connection,
Contact your local content provider or your local electronics retailer if
you are unsure about what HDTV programs are available in your area,
Broadcasters are transitioning from analog to digital TV,This means that
a given broadcaster can have channels available either in analog or in
digital, or both analog and digital at the same time.
The TV produces stereo sound only if a stereo signal is broadcast,
Connect to a cable
When yourTV is connected to the cable socket, you might receive free
digital and high definition programs (depending on your cable provider).
The channel number for digital and high definition channels includes a
dot "." For example, 11.1,46.30, 108.20I. Contact your cable provider
for more information.
8 EN
To Next Page
Loading...
