Philips 19PFL3504D - Add Channels; Optimize the Signal Quality from Your Antenna

2
PressA or T to select the channel you want to remove,then press OK,,
• The channel display for the removed channel darkens.You will
not be able to select the channel again using CH +/-.
To reactivate a removed channel, press A or T and press OK,.
The registered channels are highlighted.
• When you remove a major channel, its minor channels are
removed as well.
2
Pressa number (1 to 135) to enter the number of the channel you
want to add,then press OK,.
3 Press MENU to exit.
Add channels
• The channel with the [DTV] indicated on the display isATSC Otherwise the channel is NTSC
3 Press MENU to exit.
• If setup completes successfull)4 [Added to the channel list] is displayed.
• If external input is used, it is not possible to register the channel and [Unavailable] will be
displayed on theTV screen,
• By pressing A or V, you can select the memorized channels onl)4
Add Channels
This function lets you add the channels that were not added by the
autoprogram due to the receptible condition at the initial setup.
t Press MENU on the remote control and [SETUP] >
[Acid Channels],
Optimize the Signal Quality from Your
Antenna
You can optimize your signal quality by tuning in ATSC channels with
weak signals, and adjusting the antenna.
t Press MENU on the remote control and select [SETUP] >
[Antenna].
_- Press OK to confirm your choice.
3 Press a number (t to 135) or press CH+ or CH- to select the
channel for which you want to ched< the digital signal strength.
4 Press MENU to exit.
22 EN