1. Using ARP in Windows 98 and NT
• Start a DOS window and type the following commands.
• Example
2. Using ARP in Windows 95
• Start a DOS window and type the following commands.
• Example
3. Verifying installation
After completion, the following message (or similar) will be displayed after the
ping command:
• If you cannot receive the reply by the 'ping' command, try again by pressing
'F3' and 'Enter' keys again. Normally ‘Request timed out’ messages appear 7
times before you receive proper reply.
15
NetCam2 Section 2
arp -s <NetCam2 IP address> <NetCam2 _________ address>
ping -t <NetCam2 IP address>
arp -s 200.243.232.178 00-40-8c-10-00-86
ping -t 200.243.232.178
arp -s <NetCam2 IP add.> <NetCam2 Ethernet add.> <my PC IP add.>
ping <NetCam2 IP address>
arp -s 200.243.232.178 00-40-8c-10-00-86 200.243.232.130
ping 200.243.232.178
Request timed out
:
Request timed out
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Ping statistics for 200.243.232.178:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milliseconds:
Minimum = 1ms, Maximum = 2ms, Average = 1ms
To Next Page
Loading...
