4 CONFIGURING ADMINISTRATOR’S OPTIONS
4.1 Login
4.1.1 Accessing Administration from Setup program
• Click on the MAC address of the NetCam2.
• Type in the administrator’s password and then click the ‘Start Configuration’
button. The setup program automatically connects to the Admin page of
NetCam2's Homepage.
4.1.2 Accessing through Web browser
• On the Web browser, key in the IP address of the NetCam2 to be
configured.
• At the login page, type in the administrator’s ID and password to access the
Admin page.
Note: An administrator may also access the NetCam2 real-time image viewer, and
access the Admin page by clicking on ‘Admin’ button.
Note: The default administrator’s ID and password are both set to ‘admin’. The
administrator may change them (max 9 characters) on the Admin page.
• From the NetCam2 homepage, click on 'Administration'.
28
NetCam2 Section 4
To Next Page
Loading...
