Philips 2000i Series - Cleaning and Maintenance; Cleaning the Air Purifier Body; Cleaning the Particle Sensor; Cleaning the Filter Surface

6 EN
4 Cleaning and maintenance
Note:
• Do not attempt to clean the particle sensor with a vacuum cleaner�
• Switch o the air purier and unplug from the power socket before following action�
Cleaning the body of the air purier
Use a soft, dry cloth to clean both the interior and exterior of the air purier
and the air outlet (g u)�
Cleaning the particle sensor
Clean the particle sensor every 2 months for optimal functioning of the
appliance�
1 Clean the particle sensor inlet and outlet with a soft brush (g v)�
2 Clean the particle sensor with a damp cotton swab� Dry all parts
thoroughly with a dry cotton swab (g w)�
Cleaning the surface of the lter
Clean the surface of lter with vacuum cleaner when the lter cleaning alert
display on the screen (g x)�
1 Pull the back cover and remove it from the appliance (g c)�
2 Pull the lter from the appliance (g y)�
3 Clean the surface of the lter with a vacuum cleaner (g z)�
4 Put the lter back into the appliance (g f)�
5 Reattach the back cover (g g)�
6 Touch the button to switch on the appliance (g h)�
7 Touch and hold the lter status check/reset button for 3 seconds to
reset the lter cleaning time (g {)�
8 Wash your hands thoroughly after cleaning the lter (g |)�