Meridian 5
CC170C
W8 LCD
C
C
5. Mechanical Characteristics
5.1 Cosmetic -
Philips ID
5.2 Mechanical data files -
ProE files required
5.3 Location of Philips logo -
Per Philips make-up sheet
5.4 Gap between panel and front bezel
18.5": <0.8mm, 21.5"W: <1.2mm,
Between bezel and rear cover: ≤ 0.4mm (without art groove)
5.5 Step
Between bezel and rear cover: ≤0.4mm(Around),Rear cover can’t be higher than bezel
5.6 Location of Control icons
Per Philips graphic sheet
5.7 Color for resin/paint -
Per Philips make-up sheet
5.8 Fire Enclosure Request
Shielding cover should fulfill international standard.
5.9 Resins
RoHS required
WEEE required.
Resin type/selection refers to Project Book Section 7.2 Plastic material.
5.10 If paint is used
RoHS required
WEEE require
If new painting type needs to implement, refer to UN-D 1235.
5.11 Plastic mold tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.
5.12 Plastics flammability
All Plastics to be Flame Retardant UL 94-HB or Better.
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
5.13 Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
To Next Page
