Welcome message
The Welcome message function allows the TV
to show a customized greeting to the hotel
guest whenever the TV is switched on. This
helps to personalize the hotel experience for
guests. The Welcome message can consist
of 2 lines of text, with each line containing a
maximum of 20 alphanumeric characters. Use
▲▼◄►on the remote control to compose
the Welcome message.
Note
• To activate the Welcome message, the
[Display message] option must be [On].
Welcome message is always disabled if you •
select [Control settings] > [OSD display]
> [Off.]
[Line 1]• : Sets the characters of the
rst line message.
[Line 2]• : Sets the characters of the
second line message.
[Clear]: • Clear the settings in Line 1
and Line 2.
[Message Time-out]• : Sets the period
of time to display the welcome
message on the screen when TV is
turned on from standby / Off.
Control settings
[Local KB lock]
[Off]: • The TV local buttons
VOLUME+/-, P/CH +/- and SOURCE
will function normally.
[On]: • The TV local buttons VOLUME
+/-, P/CH +/- and SOURCE are
locked.
[All]: • All TV local buttons are locked,
including BPOWER button.
[RC lock]
Disables the operation of the Guest remote
control.
[Off]: • All buttons on Guest remote
control will function normally.
[On]: • All buttons on the Guest remote
control are disabled. (It is still possible
to enter the Professional setup menu by
pressing [3, 1, 9, 7, 5, 3+¬(MUTE)]).
[OSD display]
Sets this function to show or hide screen
information.
[Off]: • Screen information is suppressed.
[On]: • Normal screen information is
displayed.
[High security mode]
[Off]: • Professional mode setup menu
can be accessed by both Guest remote
control (Press [3, 1, 9, 7, 5, 3 +
¬(MUTE)] )and the Professional setup
remote control (Press M button)
[On]: • Professional mode setup menu
can only be accessed by the Professional
setup remote control.
[Auto scart]
Enables auto scart switching or break-in
Professional mode.
[Off]: • Disables auto scart switching or
break-in Professional mode.
[On]: • Enables auto scart switching or
break-in Professional mode.
[EXT 1]:• (SCART 1)(Only available if
EXT I source is connected to the TV).
Selects EXT I as the auto switching
source when TV restarts from standby /
Off, or when EXT 1 signal is detected.
[EXT 2]:• (SCART 2)(Only available if
EXT 2 source is connected to the TV).
Selects EXT 2 as the auto switching
source when TV restarts from standby /
Off, or when EXT 2 signal is detected.
[Power scart]: • Sets scart source as
power on / off button. When the
connected scart source is turned on /
off, the TV enters to on / standby mode
simultaneously.
Downloaded From TV-Manual.com Manuals
To Next Page