Philips 248C3LSB/00(AP) - General Product Specification (Interface Signals); Monitor Interface Signal Types Detailed

ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ
0.1 248C3 23.6” Wide 16:9 LCD Monitor
2011/05/02 PHILIPS 6 of 18
50 248C3L LCD
General Product Specification
Interface signals
1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level , input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital (248C3L only)
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3). HDMI (248C3LH only)
Follow HDMI 1.3
specification
4). HDMI audio out (headphone): (248C3LH Only)
Stereo, > 50mVrms for headphone of 32: and >0.5 Vrms for high impedance.
3.1 Interface
3.1.1 D-Sub Cable
Length : Please refer to M3 cable bundle summary file
Fix with monitor when packing, with transplant pin protective cover.
Connector type : D-Sub male with DDC2B pin assignments.
Blue connector thumb-operated jack screws
Pin assignments:
PIN No. SIGNAL
1 Red
2 Green/ SOG
3 Blue
4 Sense (GND)
5 Cable Detect (GND)
6 Red GND
7 Green GND
8 Blue GND
9 DDC +3.3V or +5V
10 Logic GND
11 Sense (GND)
12 Bi-directional data
13 H/H+V sync
14 V-sync
15 Data clock