Philips 248C3LSB/00(AP) - General Product Specification (Features); Perfect Tune II Calibration Procedure

ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ
0.1 248C3 23.6” Wide 16:9 LCD Monitor
2011/05/02 PHILIPS 11 of 18
248C3L LCD 55
General Product Specification
3.12 Pivot function (option , refer to Quick specification table)
It needs to support AUTO PIVOT function with SmartControl PC application tool.
3.13 Hot-key definition
˗ˍ˯˘ˡ˚˯˼ʳ
˽˸˶˯˸˶˯˛ˋ˯˻ʳ
˾
3.14 Smart Image
˦˴˜˴˺˸ʳˣ˹˼˿˸ʳ
˗˸˹˼˼˼ʻˠˆʼ
3.15 PerfectTune II (formerly FGA, FACTORY GAMMA Alignment)
A. PerfectTune must be done after warming 30 minutes at least.
B. PerfectTune must be performed after Auto Color.
C. PerfectTune must be conducted through DVI or scaler embedded patterns.
D. Delta E < 2.5
3.16 PowerSensor (option, refer to Quick specification table; not require in 248C3L(H))
ˣ˸ʳ˦˸ʳ
˙˶˼˴˿ʳ˥˸˼˸
˸
3.17 Smart Power (option, not require in 248C3L(H))
To reduce the power by adjusting backlight , contrast and color.
Algorithm is provided by Supplier.
3.18
SmartResponse
To enhance the Response time when Gary to Gary.
When SmartResponse= on, Response time = 2 mSec (typ.)
OD will only work after 3 frames pass to pretend user see side effect.
When smart Image set to off and color temp set to User define, OD function will work
immediately.
4 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal : As defined in 3.3, 1920 x 1080 non-interlaced mode (1920 x 1080@60 Hz)
, signal
sources must have 75 ohm output impedance.