These operations are accessible by remote control.
Some may also be accessible by the main unit's control
panel.
Setup wizard
This section will guide you through the unit’s Setup wizard which
includes selecting a language for your On-screen menu and auto
scan, which automatically scans and memorizes viewable channels.
Before you begin:
Make sure the unit is connected to an antenna or cable.
1
After making all the necessary connections, press to turn on the
unit.
Ɣ
It may take a few moments to turn on the unit for the first time.
Ɣ
Setup Wizard menu appears automatically after the unit is
turned on.
2
Use to select Menu Language and use to select English,
Spanish or French.
3
Use to select Go to next step and press OK.
4
Use to select Time Zone and use to select Pacific /
Alaska / Hawaii / Atlantic / Eastern / Central / Mountain.
5
Use to select Daylight Saving Time and use to select
On / Off.
6
Use to select Time Format and use to select 24-hour /
12-hour.
7
Use to select Go to next step and press OK.
8
Use to select Air/Cable and use to select Air / Cable.
–
When Air is selected, the TV detects antenna signals. It
searches for DTV and analog TV channels available in your
area.
–
When Cable is selected, the TV detects signals supplied by
cable. It searches for DTV, analog TV and cable channels
available in your area.
9
Use to select Go to next step and press OK.
Ɣ
Auto Tuning will begin.
Auto Tuning
Total Found
Analog
Digital
RF CH
Please press MENU key to exit
After an setup wizard is completed...
Ɣ
If you want to scan the channels automatically again.
Auto Scan p.23
Ɣ
You can add the desired cable and analog channels not memorized
by auto scan.
Favorite p.24
Ɣ
If you want to change to another language.
Menu Language p.28
15 .English
To Next Page
Loading...
