3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote control
To turn the TV on from standby or off to standby
Ɣ
Press
on the unit or the remote control.
Note(s)
Ɣ
Energy consumption contributes to air and water pollution. When the AC
power cord is plugged in, your TV consumes energy with a very low standby
power consumption.
Adjusting volume
TV
Remote control
To decrease or increase volume
Ɣ
Press VOL + / – on the TV or the remote control.
VOL + : Volume up
VOL – : Volume down
To mute or unmute sound
Ɣ
Press
on the remote control to mute the sound.
Ɣ
Press
again or VOL + to recover the original sound.
Switching channels
TV
Remote control
To select channels by using CH + / –
Ɣ
Press CH + / – on the TV or the remote control.
To select channels by using the NUMBER keys
Digital TV operation
Ɣ
For digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–
When selecting cable or analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
Ɣ
To select the non-memorized channels, use the NUMBER keys.
Ɣ
NO SIGNAL will appear on the TV screen after the subchannel broadcast is
over.
Ɣ
Audio Only message will appear on the TV screen, when you receive only
a sound signal.
16 .English
Continued on next page.
To Next Page
Loading...
