Watching channels from an external
device
Switching each input mode can easily switch with the remote control
between TV and external devices when they are connected to the
unit.
1
Turn on the set-top box or the connected device.
䐟 Press SOURCE and use to select the set-top box or the
connected device and wait a few seconds till the picture appears.
Source Select
TV
Video
HDMI1
HDMI2
MULTIMEDIA
Move Select Back
䐠 Use the remote control of the set-top box or the connected device
to select channels.
Sleep timer
Sleep timer can set the unit to go into standby mode after an
incremental period of time.
Press SLEEP repeatedly to change the amount of
time (increases the time by 5 minutes up to 240
minutes).
Press SLEEP once to call up the display for checking the remaining
time.
Ɣ
To cancel sleep timer, press SLEEP Repeatedly until Off is
displayed.
Switching audio mode
Digital TV operation
1
Press SAP to display the currently selected language.
2
Press SAP repeatedly to cycle through the available audio
languages.
7.1
KGO-HD
THE VIEW FROM THE BAYCC
TV-G720p Audio 1/3
20XX/XX/XX XX:XX
CC
HD
Good
English French Spanish
Note(s)
Ɣ
Available languages differ depending on the broadcast.
Ɣ
Other is displayed when the audio language cannot be acquired or the
acquired languages are other than English, French or Spanish.
Cable / NTSC (Analog) TV operation
1
Press SAP to display the currently selected audio mode.
2
While receiving an MTS broadcast, press SAP repeatedly to cycle
through the available audio channels.
e.g.) When all audio modes are available
Stereo Mono SAP
Stereo
: Outputs stereo audio
Mono
: Outputs mono audio
SAP
: Outputs a second audio program
5min
17 .English
Continued on next page.
To Next Page
Loading...
