!
48
Meridian 3
6. Click the “Program” to start programming after monitor power on. When it shows “Analog: PASS!, DVI: PASS!,
HDMI: PASS! and SN write OK!”. The EDID and SN writing process are finished.
13.5 Check the SN
1. Connect the VGA or DVI source and power on monitor.
2. Press the “MENU” button to enter the user menu, and then check the 14 digital SN.
3. If this SN number is the same as what we had written by EDID tool, the EDID and SN writing is completed finally
To Next Page
