Philips 273E3LHSB/00 - Ambient Temperature: 0 C - 40 C; Electrical Characteristics; Interface Signals; Scanning Frequencies

Meridian 3
67
2.3 Scanning Frequencies
Hor. : 30 - 83 K Hz
Ver. : 56 - 76 Hz
Video dot rate : RGB support up to165 MHz (Warning message must be displayed while over 165 MHz)
HDMI support up to 165 MHz
Power input : 90-264 V AC, 50/60 r 2 Hz
Power consumption : (without audio) < 40W (typ.), < 48W (max.)
Functions:
1. D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
2. SOG sync: a. Sync select : H+V
b. sync select: SERR
3. DVI/HDMI digital Panel Link TMDS inputs.
2.4 Ambient temperature: 0
q
C - 40
q
C
3. Electrical Characteristics
1.1 Interface signals
a) D-Sub Analog
Input signal : Video, Hsync, Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level, input impedance 2.2k ohm terminate
Hsync: Positive/Negative
Vsync: Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
b) DVI-D Digital (HDCP supported)
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
c) HDMI (HDMI 1.3/HDCP supported)
HDMI with HDCP, audio include, support 480i/p, 576i/p, 720p, 1080i/p
TMDS channel:
¾ Carries audio, video and auxiliary data.
¾ Signaling method: According to DVI 1.0 specification. Single-link (Type A HDMI).
¾ Video pixel rate: 25 MHz to 165 MHz (Type A)
¾ Pixel encodings: RGB 4:4:4, YCbCr 4:2:2, YCbCr 4:4:4.
¾ Audio sample rates: 32 kHz, 44.1 kHz, 48 kHz
¾ Audio channels: 2.
DDC channel:
¾ Allow source to interrogate capabilities of sink.
¾ I²C signaling with 100 kHz clock.
¾ E-EDID data structure according to EIA/CEA-861D and VESA Enhanced EDID.