16
Start a TV demo
You can use demonstrations to better
understand the features of your TV. Some
demos are not available on certain models.
Available demos are displayed in the menu list.
1 Press DEMO on the remote control.
2 Press to select a demo and press OK
to view it.
3 Press BACK to exit.
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. The channel installation
settings remain the same.
1 Press MENU .
2 Select [Setup] > [Installation] > [Factory
settings] .
3 Press to enter [Factory settings] .
4 Select [Reset] to start resetting.
5 Press OK .
6 Press MENU to exit.
Update using a USB device
Connect your USB device to the USB port at
the side of your TV.
1 If the software update screen does not
appear automatically, select [Setup] >
[Software update] > [Local updates] .
2 Press OK to update the TV software
manually.
3 Follow the on-screen instructions to
complete the update.
Note
The TV restarts after the software update is •
complete.
Change TV preferences
Use the preferences menu to customise your
TV settings.
1 Press MENU .
2 Select [Setup] > [Installation] >
[Preferences] .
• [Location] : Optimises TV settings for
your location - home or shop.
• [Volume bar] : Displays the volume
bar when you adjust the volume.
• [EasyLink] : Enables one-touch play
and one-touch standby between
EasyLink-compliant devices.
• [Pixel Plus Link] : Overrides the
settings of connected devices and
uses the settings of the TV.
• [E-sticker] : For shop mode only. Sets
the location of the e-sticker.
3 Press MENU to exit.
EN
To Next Page
Loading...
