17
Step 2 Search and store new TV
channels
1 Press MENU .
2 Press to select [Setup] >
[Installation] > [Channel install.] >
[Manual install] .
The » [Manual install] menu appears.
3 Press to select [Search] , then press
to enter.
4 Press Numeric buttons to manually enter
the three-digit frequency.
5 Press OK to begin search.
If a channel is unavailable at the »
selected frequency, the system searches
for the next available channel.
6 Press BACK when the new channel is
found.
7 Press to select [Store new channel]
to store the new channel under a new
channel number.
8 Press to enter [Store new channel] .
9 Select [OK] , then press OK to store the
new channel.
10 Press MENU to exit.
Step 3 Fine-tune analogue channels
1 Press MENU .
2 Press to select [Setup] >
[Installation] > [Channel install.] >
[Manual install] .
The » [Manual install] menu appears.
3 Press to select [Fine-tune] , then press
to enter.
4 Press to adjust frequency.
5 Press OK to con rm.
6 Press to select [Store curr. chan.] to
store the channel number.
7 Press to enter [Store curr. chan.] .
8 Select [OK] , then press OK to store
current channel.
9 Press MENU to exit.
6 Install channels
The rst time you set up your TV, you are
prompted to select a menu language and to
install TV and digital radio channels (if available).
This chapter provides instructions on how to
re-install and ne tune channels.
Automatically install channels
This section describes how to search and store
channels automatically.
1 Press MENU .
2 Select [Setup] > [Installation] >
[Channel install.] > [Channel assistant] .
3 Press OK .
4 Follow the on-screen instructions to
install channels.
Manually install channels
This section describes how to search and store
analogue TV channels manually.
Step 1 Select your system
Note
Skip this step if your system settings are •
correct.
1 Press MENU .
2 Press to select [Setup] > [Installation]
> [Channel install.] > [Manual install] .
The » [Manual install] menu appears.
3 Press to select [Colour system] , then
press
to enter.
4 Select your system, then press OK to
con rm.
5 Repeat the previous steps for [Sound system] .
6 Press MENU to exit.
English
EN
To Next Page
Loading...
