6. Channel
Installation
6.1. Antenna Installation
Update Channels
Automatic Channel Update
If you receive digital channels, you can set the TV to
automatically update these channels.
Once a day, at 7 AM, the TV updates the channels and
stores new channels. New channels are stored in the
Channels List and are marked with a . Channels
without a signal are removed. The TV must be in standby
to automatically update channels. You can switch off
Automatic Channel Update.
To switch off the automatic update:
1 - Select Settings > Channels and inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK.
2 - Enter your PIN code if necessary.
3 - Select Automatic Channel Update and press OK.
4 - Select Off and press OK.
5 - Press (left) to go back one step or press Back to
close the menu.
When new channels are found or if channels are
updated or removed, a message is shown at TV start up.
To avoid this message to appear after every channel
update, you can switch it off.
To switch off the message:
1 - Select Settings > Channels and inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK.
2 - Enter your PIN code if necessary.
3 - Select Channel Update Message and press OK.
4 - Select Off and press OK.
5 - Press (left) to go back one step or press Back to
close the menu.
In certain countries, the Automatic channel update is
done while watching TV or on any moment when the TV
is in standby.
Manual Channel Update
You can always start a channel update yourself.
To start a channel update manually:
1 - Select Settings > Channels and inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK.
2 - Enter your PIN code if necessary.
3 - Select Search for Channels and press OK.
4 - Select Start and press OK.
5 - Select Update Digital Channels, select Next and
press OK.
6 - Select Start and press OK to update the digital
channels. This can take a few minutes.
7 - Press (left) to go back one step or press Back to
close the menu.
Reinstall Channels
Reinstall All Channels
You can reinstall all channels and leave all other TV
settings untouched.
If a PIN code is set, you will need to enter this code
before you can reinstall channels.
To reinstall channels:
1 - Select Settings > Channels and Inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK.
2 - Enter your PIN code if necessary.
3 - Select Search for Channels and press OK.
4 - Select Start and press OK.
5 - Select Advanced channel reinstall and press OK.
6 - Select the country where you are now and press OK.
7 - Select the type of installation you want, Antenna
(DVB-T) or Cable (DVB-C) and press OK.
8 - Select the type of channels you want, Digital and
Analogue* Channels or Only Digital Channels and
press OK.
9 - Select Start and press OK to reinstall channels. This
can take a few minutes.
10 - Press (left) to go back one step or press Back to
close the menu.
* Note: Analogue channel support is not available for
countries that have completed analogue switched off.
Factory reset
You can redo a full TV installation. The TV is completely
reinstalled.
To redo a full TV installation:
1 - Select Settings > System > About > Reset >
Factory reset and press OK.
2 - Enter your PIN code if necessary.
3 - The TV will reinstall completely. All settings will be
reset and installed channels will be replaced. The
installation can take a few minutes.
4 - Press (left) to go back one step or press Back to
close the menu.
14
To Next Page
Loading...
