DVB Settings
Network Frequency Mode
If you intend to use the fast Quick Scan method
in Frequency Scan to search for channels,
select Automatic. The TV will use 1 of the predefined
network frequencies (or HC - homing channel) as used by
most cable operator in your country.
If you received a specific network frequency value to
search for channels, select Manual.
Network Frequency
With the Network Frequency Mode set to Manual, you
can enter the network frequency value received from
your cable operator here. To enter the value, use the
number keys.
Frequency Scan
Select the method of searching for channels. You can
select the faster Quick Scan method and use the
predefined settings used by most cable operator in your
country.
If this results in having no channels installed or if some
channels are missing, you can select the extended Full
Scan method. This method will take more time to search
for and install channels.
Frequency Step Size
The TV searches for channels in steps of 8 MHz.
If this results in having no channels installed or if some
channels are missing, you can search in smaller steps of 1
MHz. Using the 1MHz steps will take more time to search
for and install channels.
Digital Channels
If you know your cable operator is not offering digital
channels, you can skip searching for digital channels.
Analogue Channels
If you know your cable operator is not offering analogue
channels, you can skip searching for analogue channels.
Reception Quality
You can check the quality and signal strength of a digital
channel. If you have your own antenna, you can
reposition the antenna to try and improve the reception.
To check the reception quality of a digital channel:
1 - Tune to the channel.
2 - Select Settings > Channels and inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK. Enter your PIN code if
necessary.
3 - Select Digital: Reception Test and press OK.
4 - Select Search and press OK. The digital frequency is
shown for this channel.
5 - Select Search again and press OK to check the signal
quality of this frequency. The test result is shown on
screen. You can reposition the antenna or check the
connections to possibly improve the reception.
6 - You can also change the frequency yourself. Select
the frequency number one by one and use the Arrow /
navigation keys to change the value. Select Search and
press OK to test the reception again.
7 - Press (left) repeatedly if necessary, to close the
menu.
Manual Installation
Analogue TV channels can be manually installed, channel
by channel.
To install analogue channels manually:
1 - Select Settings > Channels and inputs >
Channels > Antenna/Cable Installation or Antenna
Installation and press OK. Enter your PIN code if
necessary.
2 - Select Analogue: Manual Installation and press OK.
• System
To set up the TV system, select System.
Select your country or the part of the world where you
are now and press OK.
• Search Channel
To find a channel, select Search Channel and press OK.
You can enter a frequency yourself to find a channel.
Press (right) to select Search and press OK to search for
a channel automatically. The found channel is shown on
screen and if the reception is poor, press Search again. If
you want to store the channel, select Done and
press OK.
• Store
You can store the channel on the current channel
number or as a new channel number.
Select Store Current Channel or Store as New
Channel and press OK. The new channel number is
shown briefly.
You can redo these steps until you have found all
15
To Next Page
Loading...
