available analogue TV channels.
6.2. Channel List Copy
Introduction
Channel List Copy is intended for dealers and expert
users.
With Channel List Copy, you can copy the channels
installed on one TV onto another Philips TV of the same
range. With Channel List Copy, you avoid the time-
consuming channel search by uploading a predefined
channel list on a TV. Use a USB flash drive of minimum 1
GB.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the
hardware type on the TV type plate on the back of the
TV.
• Both TVs have compatible software versions.
• For the Netherlands or any of these cable operators
(Switzerland:Sunrise / Austria:Magenta / Poland:UPC /
Romania:Vodafone / Hungary:Vodafone /
Ireland:VirginMedia), the channel list copy is limited to
satellite channel list copy. The terrestrial and cable
channels list will not be copied or erased.
Current channel version
To check the current version of the channel list:
1 - Select Settings > Channels and inputs > Channels
and select Channel List Copy.
2 - Check the version information from Current Version.
Current software version
You can go to Settings > System > About > SW
version to view the version number of current TV
software.
Copy a Channel List
To copy a channel list:
1 - Switch on the TV. This TV should have channels
installed.
2 - Plug in a USB flash drive.
3 - Select Settings > Channels and inputs > Channels
> Channel List Copy and press OK.
4 - Select Copy to USB and press OK. You might be asked
to enter the Child Lock PIN code to copy the channel list.
5 - When copying is done, unplug the USB flash drive.
6 - Press (left) repeatedly if necessary, to close the
menu.
Now you can upload the copied channel list onto
another Philips TV.
Channel List Version
Check the current version of the channel list:
1 - Select Settings > Channels and inputs >
Channels and press (right) to enter the menu.
2 - Select Channel List Copy and select Current Version,
then press OK.
3 - Press (left) repeatedly if necessary, to close the
menu.
Upload a Channel List to TV
To not Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and
select language and country. You can skip the channel
search. Finish the installation.
2 - Plug in the USB flash drive that holds the channel list
of the other TV.
3 - To start the channel list upload,
select Settings > Channels and inputs > Channels >
Channel List Copy > Copy to TV and press OK. Enter
your PIN code if necessary.
4 - The TV notifies you if the channel list is copied to the
TV successfully. Unplug the USB flash drive.
To Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this
setting, see chapter Reinstall All Channels. Start this
procedure until you reach the country setting.
Press Back to cancel the installation.)
If the country is correct continue with step 2.
If the country is not correct, you need to start a
reinstallation. See chapter Reinstall All Channels and
start the installation. Select the correct country and skip
the channels search. Finish the installation. When done,
continue with step 2.
2 - Plug in the USB flash drive that holds the channel list
of the other TV.
3 - To start the channel list upload,
select Settings > Channels and inputs > Channels >
Channel List Copy > Copy to TV and press OK. Enter
your PIN code if necessary.
4 - The TV notifies you if the channel list is copied to the
TV successfully. Unplug the USB flash drive.
16
To Next Page
Loading...
