9EN
Cleaning schedule
Cleaning method
When necessary
Wipe the fabric part of the appliance with a damp cloth,
wipe the plastic part of the appliance with a soft, dry cloth
Clean the air outlet cover
Every two months Clean the particle sensor with a dry cotton swab
The displays on the screen.
Clean the surface of the lter
Regularly clean the inside and outside of the air purier to prevent dust from collecting.
1 Wipe the fabric surface gently with a damp cloth (for AC3033/AC3039 only).
2 Use a soft, dry cloth to clean both the interior and exterior of the air purier and the air outlet.
Note:
•
The fabric covered on the appliance can not be removed.
•
Do not use hot water, alcohol, harsh cleaners to clean the fabric.
Cleaning the particle sensor
Clean the particle sensor every 2 months for optimal functioning of the appliance.
Note:
•
If the air purier is used in a dusty environment, it may need to be cleaned more often.
•
If the humidity level in the room is very high, condensation may develop on the particle sensor and
the air quality light may indicate a more poor air quality even though the air quality is actually good.
If this occurs, clean the particle sensor.
•
The gas sensor doesn’t need to be cleaned.
1 Switch o the air purier and unplug from the power socket.
2 Pull the back cover and remove it from the appliance (g c).
3 Clean the particle sensor with a damp cotton swab (g v).
4 Dry all parts thoroughly with a dry cotton swab.
5 Reattach the back cover (g g).
Action
The lter cleaning alert displays on the screen
(g w).
Clean the surface of the lter with a vacuum
cleaner�
1 Switch o the air purier and unplug from the power socket.
2 Pull the back cover and remove it from the appliance (g c).
3 Pull the lter from the appliance (g x).
To Next Page
Loading...
