11EN
2 Put the power plug in the power socket (g {).
3 Within 15 seconds after power on, touch and hold and button for 3 seconds to reset the
lter lifetime counter (g |).
6 Storage
1 Turn o the air purier and unplug from the power socket.
2 Clean the air purier, particle sensor and the surface of the lter
(see chapter “Cleaning and maintenance”).
3 Let all parts air dry thoroughly before storing.
4 Wrap the lter in air tight plastic bags.
5 Store the air purier, lter in a cool, dry location.
6 Always thoroughly wash hands after handling the lter.
7 Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, contact the Consumer Care Center in your
country.
Problem Possible solution
The appliance does not
work properly.
•
The lter replacement alert has been on continuously but you have
not replaced the corresponding lter. As a result, the appliance is now
locked. In this case, replace the lter and long press to reset the lter
lifetime counter.
The airow that comes
out of the air outlet is
signicantly weaker
than before.
•
The surface of the lter is dirty. Clean the surface of the lter (see the
chapter “Cleaning and maintenance”).
The air quality does not
improve, even though
the appliance has been
operating for a long
time�
•
Check if the packing material is removed from the lter.
•
The lter has not been placed in the appliance. Make sure that the lter
(FY3430/30) is properly installed.
•
The particle sensor is wet. The humidity level in your room is high and
causes condensation. Make sure that the particle sensor is clean and dry
(see the chapter “Cleaning and maintenance”).
•
Room size is large or the outdoor air quality is poor. For optimum
purication performance, please close the doors and windows when
operating the air purier.
•
There are indoor pollution resources. For instances, smoking, cooking,
incense, perfume or alcohol.
•
Filter reaches the end of life. Replace the lter with a new one.