Philips AC4236/10 - Cleaning the surface of the filter

11EN
English
Cleaning schedule
Frequency Cleaning method
When necessary
Wipe the fabric part of the appliance with a damp cloth,
wipe the plastic part of the appliance with a soft, dry cloth
Clean the air outlet cover
Every two months Clean the particle sensor with a dry cotton swab
When displays on the
screen
(g t)
Clean the surface of the lter
Cleaning the body of the air purier
Regularly clean the inside and outside of the air purier to prevent dust from collecting�
1 Wipe the fabric surface gently with a damp cloth�
2 Use a soft, dry cloth to clean both the interior and exterior of the air purier and the air
outlet�
Note:
• The fabric covered on the appliance can not be removed�
• Do not use hot water, alcohol, harsh cleaners to clean the fabric�
Cleaning the particle sensor
Clean the particle sensor every 2 months for optimal functioning of the appliance�
Note:
• If the air purier is used in a dusty environment, it may need to be cleaned more often�
• If the humidity level in the room is very high, condensation may develop on the particle
sensor and the air quality light may indicate a more poor air quality even though the air
quality is actually good� If this occurs, clean the particle sensor�
• The gas sensor doesn’t need to be cleaned�
1 Switch o the air purier and unplug from the power socket�
2 Pull the back cover and remove it from the appliance (g c)�
3 Clean the particle sensor with a damp cotton swab (g u)�
4 Dry all parts thoroughly with a dry cotton swab�
5 Reattach the back cover (g g)�