7EN
3 Make sure that your smartphone or tablet is successfully connected to your Wi-Fi
network�
4 Launch the “Clean Home+” app and click on “Connect a New Device” or press the “+”
button on the top of the screen� Follow the onscreen instructions to connect the air
purier to your network�
Note:
• Enterprise/Additional webpage authentication networks are not supported�
• This instruction is only valid when the air purier is being set up for the rst time� If the
network has changed or the setup needs to be performed again, see Chapter “Reset the
Wi-Fi connection” on page 7�
• If you want to connect more than one air purier to your smartphone or tablet, you have to
do this one by one�
• Make sure that the distance between your smartphone or tablet and the air purier is less
than 10 m without any obstructions�
• This App supports the latest versions of Android and iOS� Please check
www�philips�com/cleanhome for the latest update of supported operating systems and
devices�
Reset the Wi-Fi connection
Note:
• Reset the Wi-Fi connection when your default network has changed�
1 Put the plug of the air purier in the power socket and touch to turn on the air purier�
2 Touch and simultaneously for 3 seconds until you hear a beep�
» The air purier goes to pairing mode�
» The Wi-Fi indicator blinks orange�
3 Follow the steps 3-4 in “Setting up the Wi-Fi connection for the rst time” section�
4 Using the air purifier
Understanding the air quality light
The air quality light automatically goes on when the air purier is switched on, and lights up
all colors in sequence� After approximately
30 seconds, the particle sensor selects the
color that corresponds to the surrounding air
quality of airborne particles�
The color of the air quality light is determined
by the highest risk index among PM2�5, IAI
and Gas readings�
Air quality light color Air quality level
Blue Good
Blue-purple Fair
Purple-red Poor
Red Very poor
To Next Page
Loading...
