Philips AC4236/10 - Filter reset; Storage

13EN
English
Filter alert light status Action
The lter replacement alert lights
up
(g z)
Replace the NanoProtect lter Series 3
(FY4440/30)
1 Switch o the air purier and unplug from the power socket�
2 Pull the back cover and remove it from the appliance (g c)�
3 Pull the lter from the appliance (g w)�
4 Remove all packaging materials of the new lter (g e)�
5 Put the new lter into the appliance (g f)�
6 Reattach the back cover (g g)�
7 Put the plug of the air purier in the power socket�
8 Touch the button to switch on the appliance�
9 Touch and hold the lter status check/reset button for 3 seconds to reset the lter
lifetime counter (g {)�
10 Wash your hands thoroughly after replacing the lter�
Note: Do not smell the lter as it has collected pollutants from the air�
Filter reset
You can replace the lter even before lter replacement alert ( ) displays on the screen�
After replacing a lter, you need to reset the lter lifetime counter manually�
1 Touch the power button for 3 seconds to turn o the appliance and unplug from
power socket�
2 Put the power plug in the power socket (g |)�
3 Within 15 seconds after power on, touch and hold and button for 3 seconds to
reset the lter lifetime counter (g })�
6 Storage
1 Turn o the air purier and unplug from the power socket�
2 Clean the air purier, particle sensor and the surface of the lter (see chapter ‘Cleaning
and maintenance’)�
3 Let all parts air dry thoroughly before storing�
4 Wrap the lter in air tight plastic bags�
5 Store the air purier, lter in a cool, dry location�
6 Always thoroughly wash hands after handling the lter�