Philips AJ2000 User Manual

12 EN
8 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
• Make sure that the AC power plug of the
clock radio is connected properly.
• Make sure that there is power at the AC
outlet.
No response from the clock radio
• Disconnect and reconnect the AC power
plug, then turn on the clock radio again.
Poor radio reception
• Keep the clock radio away from other
electronic devices to avoid radio
interference.
• Fully extend and adjust the position of the
pig-tail antenna.
Alarm does not work
• Set the clock/alarm correctly.

Philips AJ2000 Specifications

General

Radio type	Clock
Tuner type	Digital
Auto digital tuning	Yes
Supported radio bands	FM
Display type	LED
MP3 playback	No
Product color	Mirror, White
Country of origin	China
Number of alarm times	2
Input voltage	100-240 V
Frequency range	87.5 - 108 MHz
Apple docking compatibility	Not supported
Power source	AC
AC input frequency	50 - 60 Hz
Number of built-in speakers	1
Package type	Box
Package depth	95 mm
Package width	233 mm
Package height	96 mm
Package weight	382 g
RMS rated power	- W
Harmonized System (HS) code	85271900

Weight and Dimensions

Depth	81 mm
Width	185 mm
Height	85.2 mm