Philips AJT5300 - Set time and alarm; Set time; Set alarm timer; Activate or deactivate the alarm timer

6 EN
4 Set time and
alarm
Set time
Note
• You can only set time in standby mode.
1 Press and hold SET TIME for two seconds
to activate time setting mode.
» The hour and minute digits blink.
2 Press HR repeatedly to set hour.
3 Press MIN repeatedly to set minute.
4 Press SET TIMEtoconrm.
» The set time is displayed.
Note
• If the clock radio is idle for 10 seconds, it exits time
setting mode automatically.
Set alarm timer
You can set two alarms to ring at different time.
Note
• You can only set the alarm in standby mode.
• Make sure that you have set the clock correctly.
1 Press and hold AL1 or AL2 for two
seconds to activate alarm setting mode.
» The hour and minute digits blink.
2 Press HR repeatedly to set the hour.
3 Press MIN repeatedly to set the minute.
4 Press AL1 or AL2toconrm.
5 Press HR or MIN to select an alarm
source: FM radio or buzzer.
6 Press AL1 or AL2againtoconrmthe
alarm settings.
Note
• If the clock radio is idle for 10 seconds, it exits alarm
setting mode automatically.
Activate or deactivate the alarm
timer
Press AL1 or AL2 repeatedly to activate or
deactivate the alarm timer.
» If the alarm timer is activated, [BUZZ]
or [FM] icon is displayed.
» If the alarm timer is deactivated, the
alarm icon disappears.
• To stop the ringing alarm, press the
corresponding AL1/AL2.
» Thealarmrepeatsitselfinsubsequent
days.
Note
• The alarm volume is not adjustable, but it will go up
gradually to gently wake you up.
Snooze the alarm
When the alarm goes off, press SNOOZE.
» The alarm snoozes and repeats ringing
nine minutes later.