Philips AMF220 - Getting started; Installing the filter; Setting up the remote control; Using the 3-in-1: air purifier, fan and heater

5EN
English
2 Getting started
Installing the lter
Note: Make sure the appliance is unplugged from the electrical outlet before installing the lter.
1 2 3 4 5
1 To remove the back cover, hold the side of it with both hands and pull.
2 Pull the lter from the appliance.
3 Remove all packaging materials from the lter.
4 Put the lter back into the appliance.
5 Reattach the back cover.
Setting up the remote control
1 Pull out the plastic lm on the remote control to
activate the battery.
2 Pair the remote control with the appliance if
you have multiple devices in one house (see the
chapter “Pairing your remote control”).
Note: Place the remote control in the slot and it snaps in place
automatically.
3 Using the 3-in-1: air purifier, fan and heater
Air quality light
PM2�5 level Air quality light color Air quality level
≤ 35 Blue Good
36-75 Blue-purple Fair
76-115 Purple-red Poor
> 115 Red Very poor