PCS 104 279
3-5
INSTRUCTIONS FOR USE
Do not expose the set, batteries, CDs, or tapes to humidity,
rain, sand, or excessive heat (caused by heating equipment or
direct sunlight).
The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated!
You can clean the set with a soft, slightly dampened, lint-free cloth.
Do not use any cleaning agents as they may have a corrosive effect.
To ensure proper recording and playback quality, clean parts
A, B and C after approximately 50 hours of operation. Use a
cotton swab slightly moistened with alcohol or head-cleaner fluid.
Press PLAY 1 and clean the rubber pressure roller A.
Press PAUSE ;and clean the capstan B and the heads C.
Note: Cleaning of the heads C can also be done by playing a
cleaning tape once.
The lens X of the CD player should never be touched. Always
keep the CD compartment closed to avoid dust on the lens.
The lens may cloud over when the set is suddenly moved from cold
to warm surroundings. Playing a CD is not possible then. Leave the
CD player in a warm environment until the moisture evaporates.
T
o take the CD out of its box easily, press the centre spindle while
lifting the CD.Always pick up the CD by the edge and put it back
in its box after use.
To clean the CD, wipe it in a straight line from the center toward
the edge using a soft, lint-free cloth. A cleaning agent may
damage the disc!
Never write on a CD or attach a sticker to it.
General maintenance
This set complies with the radio interference requirements of the
European Community
Problem Possible cause Solution
No sound, VOLUME is not adjusted. Adjust volume.
no power
Headphones are connected. Disconnect headphones.
Mains cable is not securely connected. Connect mains cable properly.
Batteries are flat. Insert fresh batteries.
Batteries are inserted incorrectly. Insert batteries correctly.
Trying to change over from mains to Remove the mains plug from the
battery supply without removing the plug. unit’s AC MAINS socket.
No reaction to Electrostatic discharge. Disconnect the set from power supply,
operation of any keys reconnect after a few seconds.
Poor radio reception Weak radio signal. Direct the antenna for optimum
reception.
Interference caused by electrical equipment Keep the radio away from electrical
like TVs, computers, engines, etc. equipment.
no or E indication The CD is badly scratched or dirty. Replace or clean the CD.
No CD is inserted. Insert a CD.
The CD is inserted upside down. Insert CD with label facing up.
The laser lens is steamed up. Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty. Replace or clean the CD.
SHUFFLE or PROGRAM is active. Switch off SHUFFLE or PROGRAM.
Poor cassette Dust and dirt on the heads, capstans or Clean heads, capstans, and pressure
sound quality pressure rollers. rollers.
Use of unsuitable cassette types Only use NORMAL type cassettes for
(METAL or CHROME) for recording. recording.
Recording does Cassette tab(s) may be snapped off. Apply a piece of adhesive tape over
not work the opening.
Remote control does Batteries are inserted incorrectly. Insert batteries correctly.
not function properly
Batteries are flat. Insert fresh batteries.
Distance to the set is too large. Reduce distance.
WARNING
Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
To Next Page
Loading...
