INSTRUCTIONS FOR USE
3-2
PCS 104 412
Whenever convenient, use the mains supply if you want to
conserve battery life. Make sure you remove the plug from the set
and wall socket before inserting batteries.
BATTERIES (OPTIONAL)
1. Open the battery compartment and insert six batteries, type
R-14, UM-2 or C-cells, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.
Remote control (supplied)
Open the battery compartment and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– If BA
TT LOW
lights up, batter
y power is running low.
– The BATT LOW indicator eventually goes out if the
batteries are too weak.
Incor
rect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
• Do not mix battery types: e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
• When inserting new batteries, do not tr
y to mix old batteries
with the new ones.
•
Remove the batteries if the set is not to be used for a long
time.
• Batteries contain chemical substances, so they should
be disposed of properly.
Using AC MAINS
1. Check if the mains voltage as shown on the type plate on
the base of the set, corresponds to your local mains supply. If
it does not, consult your dealer or service centre.
2. If your set is equipped with a voltage selector, adjust the
selector so that it matches with the local mains supply.
3. Connect the mains lead to the wall socket and the set is now
ready for use.
4. To disconnect the set from the mains supply completely
,
remove the plug from the wall socket.
Switching on and off
• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE/OFF.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the keys on the tape deck are released.
™The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. Press the VOL +, – controls to increase or decrease VOLUME
(or press 3 or 4 on the remote control).
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. On the set, press the CD STOP 9 button for 5 seconds.
™PH..IL ..IPS scrolls across the display continuously.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts the
demo mode for 30 seconds;
• press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather
.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
To Next Page
Loading...
