INSTRUCTIONS FOR USE
3-6
PCS 104 416
PROBLEM
– POSSIBLE CAUSE
•
REMEDY
No sound/power
– Volume not adjusted
• Adjust the volume
– Headphones connected
• Disconnect headphones
– Mains lead not securely connected
• Connect the mains lead properly
Severe radio hum or noise
– Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
– Weak radio signal
• FM: Direct the FM telescopic aerial for
optimum r
eception
• MW (AM): Tur
n the set for optimum
reception
or indication
– No CD inserted
•
Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see CD player and
CD handling
– Laser lens steamed up,
•
W
ait until lens has cleared
indication
– CD-R(W) is blank or the disc is not finalised
• Use a finalised CD-R(W)
– CD badly scratched or dirty
• Replace/ clean CD, see CD player and
CD handling
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or a programme is active
• Switch of
f SHUFFLE/PROGRAM
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
–
Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–
Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
Remote control does not function properly
– Batteries dead/ incorrectly inser
ted
• Insert (fresh) batteries cor
rectly
– Distance/ angle between the set too lar
ge
•
Reduce the distance/ angle
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
The typeplate is located on the bottom of the set.
To Next Page
Loading...
