Philips AZ3831 - Getting Started with Your Device; Remote Control Setup; Installing Batteries in the Unit

9EN
3 Get started
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your apparatus. The
model number and serial number are on the
bottom of your apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Install batteries
Note
• You can use both batteries and AC power as power
supply of this apparatus.
• Batteries are not supplied with the accessories.
1 Open the battery compartment.
2 Insert 8 batteries (type: R-20, UM-1 or
D-cells) with correct polarity (+/-) as
indicated.
3 Close the battery compartment.
a
b
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Risk of decreased battery life! Never mix different
brands or types of batteries.
• Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
For rst-time use:
1 Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert 1 CR2025 battery with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
1
2
3
1
2
3