Philips AZ9040 - Installation

CONTROLS
e Insert as indicated six (preferably Alkaline) batteries,
type R20, UM1 or D-cells.
“ua
“a
“ue.
-
t =
és
A q
PR
Saana”
e The battery supply is switched off when the set is
connected to the mains. When changing over to battery
supply, remove the plug from the MAINS socket (9.
e Remove the batteries if exhausted or if they will not be
used again for a long period.
Important notes for users in the UK:
Mains Plug
This apparatus is fitted with an approved moulded 13
Amp plug.
To change 8 fuse in this type of plug proceed as
follows:
e Remove fuse cover and fuse.
e Fix new fuse which should be a BS1362 SA,
A.S.T.A. or BSI approved type.
o Refit the fuse cover.
if the fitted plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fitted in its
place.
lf the mains plug contains a fuse, this should have a
value of 5 A. If a plug without a fuse is used, the fuse
at the distribution board shoutd not be greater than
5A.
Note:
The severed plug must be destroyed to avoid a
possible shock hazard should ithe inserted i intoa 13 A
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the
following code: blue = neutral (N), brown = live. (1)
As these colours may not correspond with the colour
markings identifying the terminais in your plug, pro-
ceed as follows:
e Connect the blue wire to the terminal marked N or
coloured black.
e Connect the brown wire to the terminal marked L
or coloured red.
e Do not connect either wire to the earth terminal in
the plug, marked E (or +) or coloured green (or
green and yellow).
Before replacing the plug cover, make certain that the
cord grip is clamped over the sheath of the lead — not
simply over the two wires.
Copyright:
Recording and playback of material may require con-
sent. See Copyright Act 1956 and The Performer's
Protection Acis 1958 to 1972.
mm A
INSTALLATION
AC mains supply
e Check if the mains voltage as shown on the type plate
(on the base of the set) corresponds to your local mains
supply. If it does not, consult your dealer or service
organisation.
If the set is equipped with a VOLTAGE selector G&G), set
this selector to the local mains voltage.
e Connectthe mains lead to the MAINS socket @ andthe
wall socket. The mains supply is now connected.
e To disconnect the set from the mains, withdraw the
mains plug from the wall socket.
CONNECTIONS
Stereo headphone socket @ Q
For stereo headphones with 3.5 mm plug. Inserting the
plug will disconnect the loudspeakers.
Microphone socket MIC MIXING
For a microphone with 3.5 mm plug. To avoid disturbing
noises, reduce the volume before connection.
— you can reproduce your voice amplified through the
loudspeakers. Set MODE selector (6) to TAPE.
ad
co RADIO TAPE
— you can mix your voice with CD, radio or cassette. Set
the MODE selector © to CD, RADIO or TAPE. Inthe CD
or RADIO mode you can record it all on the cassette
deck.
— aee