Philips CD280 - Register Handsets; Unregister Handsets; Restore Default Settings

23EN
Register the handsets
You can register additional handsets to the base
station. The base station can register up to 5
handsets.
1 Select [Menu] > [Services] > [Register],
then press [OK]toconrm.
2 Press and hold on the base station for
5secondsuntilyouhearaconrmation
beep, then press [OK]toconrm.
3 Enter the system PIN. Press [Clear] to
make corrections.
4 Press [OK]toconrmthePIN.
Registration is completed in less than »
2 minutes. The base automatically
assigns a handset number to the
handset.
Note
If the PIN is incorrect or no base is found •
within a certain period, your handset displays
anoticationmessage.Repeattheabove
procedure if registration fails.
Note
The preset PIN is 0000. No change can be •
made on it.
Unregister the handsets
1
If two handsets share the same base
station, you can unregister a handset with
another handset.
2 Select [Menu] > [Services] >
[Unregister], then press [OK]toconrm.
3 Select the handset number to be
unregistered.
4 Press [OK]toconrm.
The handset is unregistered. »
Tip
The handset number displays beside the •
handset name in standby mode.
Restore default settings
You can reset your phone settings to the
original factory settings.
1 Select [Menu] > [Services] > [Reset],
then press [OK]toconrm.
Thehandsetdisplaysaconrmation »
request.
2 Press [OK]toconrm.
All settings are reset. »
Tip
For more information about the default •
settings, see the section on Default settings.
English