15
EN
Install
Set date and time
1. Press mMENU.
2. Scroll
: to Clock & Alarm and press mSELECT.
3. Press
mSELECT to enter Set Date/Time.
4. Enter current time (HH:MM) and current date (DD/MM/YY) and press
mSELECT.
Now, you are ready to use your phone.
Basic operations of your CD535
Make a call
Enter the phone number (maximum 24 digits) and press r to dial the number.
For details, please refer to "Make a call" on page 18.
Answer or end a call
Press r key to answer a call.
Press
e key to end a call.
For details, please refer to "Answer a call" and "End a call" on page 19.
Switch the handset on/off
Press and hold e key for 5 seconds to switch off the handset in stand-by mode.
Short press
e key to switch on the handset again.j
Keypad lock/unlock
Press and hold * key for 2 seconds to lock and unlock the keypad in stand-by mode.
Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
Press c key on the base until the handset starts to ring.
Once retrieved, press
e to end the paging.
WARNING If your phone is connected to an ISDN line through an adaptor, the date & time may
be updated after each call. The availability of date & time update is dependent on your network
provider. Please check the date & time settings in your ISDN system or contact your network
provider.
CD535_IFU_EN.book Page 15 Monday, September 25, 2006 1:15 PM
To Next Page
Loading...
