Philips CDC 936 - Calling up Other Information on the Display; Scanning Cds; Repeating Play

English
®) PLAYBACK
1 1 1
SmfCP PUY/mUY PAUSE ^ITLE REPEAT
I-M wl
PEAK
SCAR 8SIRCH PAOBI
1 1 1
CALLING UP INFORMATION ON THE DISPLAY (DISPLAY) SCANNING CDs (SCAN)
IN STOP MODE:
Text display
- As soon as the CDs contents list has been scanned (after
loading the CDs and closing the CD compartment), the
display shows the CD number or name (if stored in the
FTS/TITLE memory). This is the default display in ST OP
mode.
During play:
7. Time display
- When you start play (from STOP mode), the display shows
the elapsed playing time of the current track (= default
display in PLAY mode).
2T4S«7«-«10 41
• Press DISPLAY 75whenever you want to know the
remaining playing time of the current track (REM TRACK
TIME).
2 f 4 S -9 7
RCM TPACK TBK
« -• t» 41
• Press DISPLAY again if you wish to know the remaining
playing time of the entire CD (TOTAL REM TIME).
total ftEM nte
3j4S47«'»l(r41
A/ofe - TOTAL REM(aining) TIME indication is not available in
SHUFFLE mode.
2.Text display
♦ If you press DISPLAY again, you will switch to text display;
the display shows the number or the name (if stored in the
FTS/TITLE memory) of the current CD (= default displayjn
STOP mode).
• If you wish to know the total playing time of the entire CD
you must go back to STOP mode f/rst and then press
DISPLAY.
- The display now shows the number of tracks and the total
playing time of the current CD (TOTAL TIME).
All CDs:
• Press SCAN 22 before or during play.
- If the CD compartment was open, it will now close.
- bCRN lights up and the first 10 seconds of each track are
played in turn (starting from the current track).
10 seconds are counted down each time under REM(aining)
TRACK TIME.
TRACK R£ll TRACK TWe
4 S •« T 4 4 19 4t
• When the changer reaches a track which you wish to hear in
full, press SCAN again or PLAY/REPLAY 7S.
One CD:
• The CD-changer should be in STOP mode.
• Select the number of the required CD using DISC SELECT
70 or DISC 6 (on the remote control).
• Press SCAN 22, within 1.5 seconds.
- Now only the first 10 seconds of each track on the selected
CD will be played in turn.
Other scan times can be entered in the PRESETS mode. For
this refer to the chapter 'PERSONAL PRESETS'.
REPEATING PLAY (REPEAT) _
Repeating a CD:
• Press REPEAT 21 before or during playback of the CD.
’’ REPEAT DISC lights up; the CD will now be repeated
continuously.
• Press REPEAT twice to stop the CD being repeated.
Repeating all CDs:
• Press REPEAT 21 twice before or during playback.
- REPEAT lights up; all CDs will now be repeated continuously.
TRACK TRACK TWC
rr /• Zf ZJ
«ef«AT $ « 7 « 19 41
• Press REPEAT again to stop the CDs being repeated.
NOTE!
When a programmeme has been stored (for one or more CDs),
then only the programmeme will be repeated
12